USB to TTL Serial Cable
Description
The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36″ cable are four wire – red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.
₨1,400
CompareUSB to TTL Serial Cable
This is a USB to TTL Serial Cable which allows for a simple way to connect TTL interface devices to USB. The I/O pins of this cable are configured to operate at 3.3V specifically with a Raspberry Pi with each serial pin broken apart. Thanks to its separated pins, this cable is a perfect candidate for powering, connecting, and accessing the login and debug console on the Raspberry Pi.
The FTDI cable is designed around an FT232, which is housed in a USB-A connector. The other side of the cable is terminated with a separated 4-pin connector with the following pinout: RX (Yellow), TX (Orange), VCC (Red), and GND (Black)..
The USB TTL Serial cables are a range of USB to serial converter cables which provide connectivity between USB and serial UART interfaces.Ā A range of cables are available offering connectivity at 5V, 3.3V or user specified signal levels with various connector interfaces.
All cables feature an FTDI FT232R device integrated within the cable USB type āAā connector, which provide access to UART Transmit (Tx), Receive (Rx), RTS#, CTS#, VCC (5V) and GND connections.Ā All cables are fully RoHS compliant and are FCC/CE approved.
Note:Ā Please be aware that while the I/O pins in this cable operate at 3.3V, the VCC pin is 5V. The VCC pin is NOT 3.3V like the I/O pins.
Based on 0 reviews
Be the first to review “USB to TTL Serial Cable”
You must be logged in to post a review.
Related products
-
Modules/Motors, Project Boards
Logic Analyzer EEPROM CY7C68013A-56 EZ-USB FX2LP USB2.0 Develop Board Module
Modules/Motors, Project BoardsLogic Analyzer EEPROM CY7C68013A-56 EZ-USB FX2LP USB2.0 Develop Board Module
1. Adopt cy7c68013a-56 chip: low-power version, enhanced 51 core, 16KB program data area, 48Mhz main frequency, 480Mbps high-speed transmission protocol standard, which is in conformity with USB2.0 specification and downward compatible with USB1.1.
2. Firmware EEPROM: the complete system programming scheme is used to download firmware programs directly using USB cable. The board provides 16K (24LC128) large-capacity program memory (EEPROM), which is used to store VID/PID and USB firmware, meeting the program space requirements of CY7C68013A.
3. All GPIO are introduced through 2.54mm standard needle discharge, which is greatly convenient for learners to extend the design by themselves.
4. With the corresponding firmware, the functions of the logic analyzer can be realized through the core board.
5. Provide schematic diagram in PDF format and relevant source code.SKU: n/a
There are no reviews yet.