Special Offer

TEC1-12706 wholesale price in Pakistan
₨350-
Raspberry Pi
Camera with Flash for Raspberry Pi
Features
The LISIPAROI can be powered by the Raspberry Pi or by an external power supply.
Brightness can be controlled digitally by PWM or analogue by varying the voltage between 0 and 3v.
- White or Infrared LEDs
- Flash or Steady Light
- Powered by Pi or separate battery pack
- Attaches to existing camera module
- Brightness control
- Additional mounting points
- Perfect for security or timelapse photography
SKU: n/a
-
Micro Controllers
Atmega328p-au 28 Pin Micro Controller Best Price in Pakistan
The Atmel – ATmega328/P is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328/P achieves throughputs close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.
SKU: n/a
-
-
Modules/Motors
XL6009 LM2596S DC-DC Up Down Boost Buck Voltage Power Converter Module
Features:
Brand new and high quality.Input: 3.5-28V.
Output: 1.25V-26V.
Output voltage independent of input voltage (3.5V-28V input, any value output 1.25V-26V).
Maximum input current 3A.
Maximum output 3A.
SKU: n/a -
Tools & Kits
RC B3 LIPO BATTERY CHARGER
With the development of electric technology, we have a new design of easy compact balance chargerfor 2 and 3 cells LiPo battery fast charging with wide AC input.?internal 100-240V AC switch?power is built in, and the high precision balance system can provide more current to 850mA per cell.?Double color LED can display the charging process (RED: charging; GREEN: full)
SKU: n/a
Products Grid
Best Sellers
Added
MCP 602
The MCP602 dual operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 uA and an offset voltage that is less than 2 mV. The MCP602 uses Microchip’s advanced CMOS technology, which provides low bias current, high-speed operation, high open-loop gain and rail-to-rail output swing. The MCP602 operates with a single supply voltage that can be as low as 2.7V, while drawing less than 325 of quiescent current per amplifier. The MCP602 is available in standard 8-lead PDIP, SOIC and TSSOP packages. This amplifier is ideal for industrial process control, low-power battery-operated devices, portable equipment, data acquisition equipment, test equipment and low-end audio applications.
MAX 488
Key Features
Max 487
Key Features
Max 485
Key Features
Max 232
Features
±15 kV Using Human-Body Model (HBM)
PIC 16F72 Refurbished
MEMORY ORGANIZATION
There are two memory blocks in the PIC16F72 device. These are the program memory and the data memory. Each block has separate buses so that concurrent access can occur. Program memory and data memory are explained in this section. Program memory can be read internally by the user code (see Section 7.0). The data memory can further be broken down into the general purpose RAM and the Special Function Registers (SFRs). The operation of the SFRs that control the “core” are described here. The SFRs used to control the peripheral modules are described in the section discussing each individual peripheral module. Additional information on device memory may be found in the PIC™ Mid-Range Reference Manual, (DS33023).
PIC 16F628
Product Development
The PIC16F627A/628A/648A family is supported by a full-featured macro assembler, a software simulator, an in-circuit emulator, a low cost in-circuit debugger, a low cost development programmer and a full-featured programmer. A Third Party “C” compiler support tool is also available.