2.4 INCH TFT LCD FOR ARDUINO
Out of stock
- 2.4″ diagonal LCD TFT display
- 240×320 resolution
- 5V compatible! Use with 3.3V or 5V logic
- Onboard 3.3V 300mA LDO regulator
- 8 bit digital interface, plus 4 control lines
- 4-wire resistive touchscreen
- Uses digital pins 5-13 and analog 0-3. That means you can use digital pins 2, 3 and analog 4 and 5. Pin 12 is available if not using the microSD
₨650
Out of stock
CompareBased on 0 reviews
Be the first to review “2.4 INCH TFT LCD FOR ARDUINO”
You must be logged in to post a review.
Related products
-
Arduino, Modules/Motors
5A Monophase Active Output AC Current Transformer Module For Arduino
1, On-board precision micro-current transformer
2, On-board high-precision op-amp circuit, to do accurate sampling and appropriate compensation and other functions to signal
3, The module can measure AC current within 5A, corresponding output analog can be adjusted
4, Under ideal conditions, the input voltage VCC is 3-35V, according to the potentiometer (adjust the amplification ratio, amplification range 0-100 times) to adjust the required output voltage, but the output (OUT) of the maximum voltage does not exceed 1 / 2 VCC.
5, The output signal is the AC voltage signal, and the output signal voltage does not exceed the maximum 1 / 2VCC.
6, PCB board size: 38 (mm) x 18.5 (mm)SKU: n/a -
Arduino, Modules/Motors
Mini W5100 Ethernet Network Module Board For Arduino
You can choose a variety of interfaces: direct bus, indirect bus and SPI bus
Support for hardware TCP / IP protocol stack, support TCP, UDP, ICMP, IGMP, IPv4, ARP, PPPoE
Up to four independent ports
Internal integration 16 kbyte transceiver cache
A variety of information outputs, including the RX, TX, Full / Duplex, Collision, Link, Speed
Support auto-polarity transformation (DMI / MDIX)
3.3V power supply, IO signal compatible with 5V voltage
It comes with Ethernet port, 2 * 14 2.0mm double row
Compatible the official Arduino Ethernet librarySKU: n/a -
-
Arduino
Buy Arduino Uno price in Pakistan
Technical Specifications
Microcontroller ATmega328 Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limits) 6-20V Digital I/O Pins 14 (of which 6 provide PWM output) Analog Input Pins 6 DC Current per I/O Pin 40 mA DC Current for 3.3V Pin 50 mA SKU: n/a
There are no reviews yet.