Based on 0 reviews
Be the first to review “Soldering Wire 100g”
You must be logged in to post a review.
You must be logged in to post a review.
1. 100MHz bandwidth, 1GSa/s real-time sampling rate
2. 2 channels
3. 25kpts memory depth
4. 20,000wfms/s waveform acquisition rate
5. 2ns/div~50s/div time-base
6. Trigger modes: Edge, Pulse Width, Runt, Over-amplitude, Slope and Video
7. Calibration Signal Output: 10Hz, 100Hz, 1kHz (default), 10kHz and 100kHz
8. Input calibration signal only by pressing a button
9. 10Mpts waveform recording
10. 8-inch TFT LCD, WVGA (800×480)
11. USB OTG and Pass/Fail interfaces
Input voltage range: 3.5V-30V(Note: 30V is the maximum voltage, when use please make sure input lower than 30V, otherwise will burn out.)
Output voltage range: 3.5V-30V (boost mode, the input must be less than or equal to the output voltage)
Maximum input current: 10A (peak current)
Continuous Current: 6A
Size: 67cm(L) * 42cm(W) * 18cm(H)
Output power: Max 100W {Note: according to the law of conservation of power, computation under the condition of rated output current: Uin*Iin*efficiency =Uout*Iout(Uin:input voltage, Iin:input current)}
Weight: 35g
Color: Red
Voltmeter Accuracy: ± (5 ‰ + 1 digit)
Static power consumption:Typical about 15mA(With the input voltage, output voltage and the color is closely related to the digital pipe. The actual current there is a deviation)
IN +: Positive Input, IN-: Negative Input. OUT +: Positive output, OUT-: Negative output.
There are no reviews yet.