CNC SHIELD V4 CONTROLLER BOARD FOR NANO
CNC Shield V4.0 can be used as a drive expansion board
₨280
CompareBased on 0 reviews
Be the first to review “CNC SHIELD V4 CONTROLLER BOARD FOR NANO”
You must be logged in to post a review.
Related products
-
Arduino, Raspberry Pi
16-Channel 12-bit PWMServo Driver ā I2C interface ā PCA9685 for Arduino Raspberry Pi DIY Servo Shield
Arduino, Raspberry Pi16-Channel 12-bit PWMServo Driver ā I2C interface ā PCA9685 for Arduino Raspberry Pi DIY Servo Shield
he PWM driver board uses the I2C method, so only four lines can be connected to the Arduino device:
āClassicā Arduino pin mode:
+ 5v -> VCC
GND -> GND
Analog 4 -> SDA
Analog 5 -> SCL
Old Mega pin way:
+ 5v -> VCC
GND -> GND
Digital 20 -> SDA
Digital 21 -> SCLSKU: 950 -
Arduino, Modules/Motors
5A Monophase Active Output AC Current Transformer Module For Arduino
1, On-board precision micro-current transformer
2, On-board high-precision op-amp circuit, to do accurate sampling and appropriate compensation and other functions to signal
3, The module can measure AC current within 5A, corresponding output analog can be adjusted
4, Under ideal conditions, the input voltage VCC is 3-35V, according to the potentiometer (adjust the amplification ratio, amplification range 0-100 times) to adjust the required output voltage, but the output (OUT) of the maximum voltage does not exceed 1 / 2 VCC.
5, The output signal is the AC voltage signal, and the output signal voltage does not exceed the maximum 1 / 2VCC.
6, PCB board size: 38 (mm) x 18.5 (mm)SKU: n/a
There are no reviews yet.