CNC SHIELD V4 CONTROLLER BOARD FOR NANO
CNC Shield V4.0 can be used as a drive expansion board
₨280
CompareBased on 0 reviews
Be the first to review “CNC SHIELD V4 CONTROLLER BOARD FOR NANO”
You must be logged in to post a review.
Related products
-
Arduino, Modules/Motors
5A Monophase Active Output AC Current Transformer Module For Arduino
1, On-board precision micro-current transformer
2, On-board high-precision op-amp circuit, to do accurate sampling and appropriate compensation and other functions to signal
3, The module can measure AC current within 5A, corresponding output analog can be adjusted
4, Under ideal conditions, the input voltage VCC is 3-35V, according to the potentiometer (adjust the amplification ratio, amplification range 0-100 times) to adjust the required output voltage, but the output (OUT) of the maximum voltage does not exceed 1 / 2 VCC.
5, The output signal is the AC voltage signal, and the output signal voltage does not exceed the maximum 1 / 2VCC.
6, PCB board size: 38 (mm) x 18.5 (mm)SKU: n/a -
Arduino, Modules/Motors, Raspberry Pi
6-Digit 8 Segment Tube LED Display Module TM1637 for Arduino Raspberry PI
Arduino, Modules/Motors, Raspberry Pi6-Digit 8 Segment Tube LED Display Module TM1637 for Arduino Raspberry PI
– Using CMOS technology
– Display mode (6-Digit 8 Segment), support a total of positive digital tube output
– Key scan (8X2bit), enhanced anti-jamming key recognition circuit
– Gray scale adjustment circuit (duty cycle 8 adjustable)
– Two-wire serial interface (CLK, DIO)SKU: n/a -
Arduino, Modules/Motors
AC Voltage sensor module ZMPT101B 250V Voltage transformer module Arduino
- Measure within 250V AC
- Onboard micro-precision voltage transformer
- Analog output corresponding quantity can be adjusted.
- Good consistency, for voltage and power measurement
- Very efficient and accuracy
SKU: n/a -
Arduino
43A H Bridge Drive PWM For Arduino Semiconductor BTS7960B
This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A
SKU: n/a
There are no reviews yet.