Based on 0 reviews
Be the first to review “PIC 16F73”
You must be logged in to post a review.
Related products
-
Micro Controllers
ATML – AT89S52
Features
- Compatible with MCS®-51 Products
- 8K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 10,000 Write/Erase Cycles
- 4.0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 256 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Three 16-bit Timer/Counters
- Eight Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
- Green (Pb/Halide-free) Packaging Option
SKU: n/a -
Micro Controllers
PIC 16F72 Refurbished
MEMORY ORGANIZATION
There are two memory blocks in the PIC16F72 device. These are the program memory and the data memory. Each block has separate buses so that concurrent access can occur. Program memory and data memory are explained in this section. Program memory can be read internally by the user code (see Section 7.0). The data memory can further be broken down into the general purpose RAM and the Special Function Registers (SFRs). The operation of the SFRs that control the “core” are described here. The SFRs used to control the peripheral modules are described in the section discussing each individual peripheral module. Additional information on device memory may be found in the PIC™ Mid-Range Reference Manual, (DS33023).
SKU: n/a -
Micro Controllers
ATML – AVR AT Tiny85
Features
High Performance, Low Power AVR® 8-Bit Microcontroller
Advanced RISC Architecture – 120 Powerful Instructions – Most Single Clock Cycle Execution – 32 x 8 General Purpose Working Registers – Fully Static Operation
Non-volatile Program and Data Memories
- – 2/4/8K Bytes of In-System Programmable Program Memory Flash
- – 128/256/512 Bytes In-System Programmable EEPROM
- – 128/256/512 Bytes Internal SRAM
- – Programming Lock for Self-Programming Flash Program and EEPROM Data Security
Peripheral Features
– 8-bit Timer/Counter with Prescaler and Two PWM Channels
– 8-bit High Speed Timer/Counter with Separate Prescaler
- 2 High Frequency PWM Outputs with Separate Output Compare Registers
- Programmable Dead Time Generator
– USI – Universal Serial Interface with Start Condition Detector – 10-bit ADC
4 Single Ended Channels
2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
Temperature Measurement
- – Programmable Watchdog Timer with Separate On-chip Oscillator
- – On-chip Analog Comparator
Special Microcontroller Features
- – debugWIRE On-chip Debug System
- – In-System Programmable via SPI Port
- – External and Internal Interrupt Sources
- – Low Power Idle, ADC Noise Reduction, and Power-down Modes
- – Enhanced Power-on Reset Circuit
- – Programmable Brown-out Detection Circuit
- – Internal Calibrated Oscillator
I/O and Packages
- – Six Programmable I/O Lines
- – 8-pin PDIP, 8-pin SOIC, 20-pad QFN/MLF, and 8-pin TSSOP (only ATtiny45/V)
- Operating Voltage
- – 1.8 – 5.5V for ATtiny25V/45V/85V
- – 2.7 – 5.5V for ATtiny25/45/85
Speed Grade
- – ATtiny25V/45V/85V: 0 – 4 MHz @ 1.8 – 5.5V, 0 – 10 MHz @ 2.7 – 5.5V
- – ATtiny25/45/85: 0 – 10 MHz @ 2.7 – 5.5V, 0 – 20 MHz @ 4.5 – 5.5V
Industrial Temperature Range
Low Power Consumption
- – Active Mode: 1 MHz, 1.8V: 300 µA
- – Power-down Mode: 0.1 µA at 1.8V
SKU: n/a
There are no reviews yet.